Filter
Top Products
Mixdown and bounce operations
88
6
Raise the [STEREO] fader and the faders of
the track channel(s) you selected as the
bounce-destination to the 0 dB position.
7
While you play back the song, raise the fad-
ers of the bounce-source track channels to an
appropriate level. Adjust the pan, EQ, and
dynamics of each track channel as necessary.
Note
Note
The bounce-destination faders will not affect the content
that is recorded. However, the bounce-source faders
specify the volume balance that will be recorded.
8
Press the RTZ [ ] key to rewind the song.
Then hold down the REC [●] key and press
the PLAY [ ] key.
The song will begin playing back, and will be
recorded on the bounce-destination track(s).
9
When you reach the end of the song, stop
the song and press the RTZ [ ] key to
rewind.
10
To check the recorded result, move the cur-
sor to the SAFE button and press the [ENTER]
key to cancel the recording settings.
11
Access the ON/OFF page of the MONITOR
screen (→ p. 31), turn off all track channels
other than the bounce-destination, and press
the PLAY [ ] key.
Tip!
Tip!
• If you attempt to change the screen or page without
using the SAFE button, a popup window asking “Clear
Current REC Setting?” will appear, asking you whether
it is ok to clear the current recording settings. Move the
cursor to the OK button and press the [ENTER] key.
• If desired, you can use the [UNDO/REDO] button to
cancel the bounce-recording operation (
→
p. 61), or
switch the virtual track of the bounce-destination and
record another take (
→
p. 62).