Filter
Top Products
89
Mixdown and bounce operations
9
Convenient functions during mixdown/
bounce operations
Here are some convenient functions that you can use
during mixdown or bounce operations.
Adding input signals or pad per-
formances during mixdown
During mixdown, you can add signals from the input
channels or pad channels. For example, you could add a
performance from a workstation-type synthesizer (with
built-in sequencer) that is synchronized to the AW16G
song, or add sound effects that have been assigned to the
pads. To do this, perform the following steps after you
have completed “Preparing for mixdown” (→ p. 83).
1
In the Quick Navigate section, repeatedly
press the [RECORD] key or hold down the
[RECORD] key and use the CURSOR [ ]/[ ]
keys to access the MIXDOWN page of the
RECORD screen.
2
Press the [INPUT SEL] key or pad that corre-
sponds to the input channel or pad channel
you want to use, to add that channel as a
mixdown-source.
3
In the Selected Channel section, repeatedly
press the [PAN/BAL] knob or hold down the
[PAN/BAL] knob and use the CURSOR [ ]/
[] keys to access the PAN page of the PAN
screen.
Note
Note
If the page you see is different than shown above, make
sure that input channels/pad channels are selected as the
object of your operations. (This is shown in the upper left
of the screen.) If track channels are selected, press one of
the [INPUT SEL] keys or pads.
4
Move the cursor to the PAN knob of the
channel you want to use, and turn the
[DATA/JOG] dial to adjust the pan setting.
5
In the Selected Channel section, repeatedly
press the [VIEW] key or hold down the [VIEW]
key and use the CURSOR [ ]/[ ] keys to
access the FADER page of the VIEW screen.
In the FADER page of the VIEW screen, you can use
on-screen faders to adjust the faders (input level) of
each channel.
1 ON/OFF buttons
These buttons switch each channel on/off.
B Faders
These faders adjust the input level of each channel.
6
While you play back the song, move the cur-
sor to the on-screen faders and turn the
[DATA/JOG] dial to adjust the level of the
input channels/pad channels that you want
to use.
7
If necessary, adjust EQ, dynamics, and the
send level to the internal effects for each
input channel or pad channel.
Now you have completed the preparations for add-
ing input channel or pad channel signals to the mix-
down. Record the mixdown on the stereo channel
as described in “Recording on the stereo track” (→
p. 86).
1
2