Filter
Top Products
159
MIDI and utility functions
14
Using the test tone oscillator
The OSC page of the UTILITY screen lets you send the
signal of the AW16G’s built-in test oscillator (the test
tone oscillator) to the desired bus.
To access this page, repeatedly press the Work Navigate
section [UTILITY] key or hold down the [UTILITY] key
and use the CURSOR [ ]/[ ] keys.
This page contains the following items.
1 WAVEFORM
Selects one of the following signals for output from
the oscillator.
OFF button ................ Oscillator is off
100Hz button ............ 100 Hz sine wave
440Hz button ............ 440 Hz sine wave
1kHz button............... 1 kHz sine wave
10 kHz button............ 10 kHz sine wave
NOISE button ............ White noise
When you turn on a button, the oscillator output
will immediately be sent to the specified bus. Use
the
3–6 buttons to specify the bus to which the
signal will be sent.
Tip!
Tip!
If the LEVEL knob is raised when you output the oscilla-
tor signal, a high volume level may be produced sud-
denly. Be sure to lower the LEVEL knob before you switch
on the oscillator.
B LEVEL knob
Adjusts the output level of the oscillator.
C AUX 1/2 buttons
Send the oscillator output to AUX buses 1/2.
D EFF 1/2 buttons
Send the oscillator output to effect buses 1/2.
E BUS L R button
Sends the oscillator output to the L/R bus.
F STEREO L R button
Sends the oscillator output to the stereo bus.
G Level meter
Indicates the output level of AUX 1/2, effect bus 1/
2, and the L/R bus.
Note
Note
Sine waves and white noise have a higher sound pressure
than they perceptually appear. These signals may damage
your speakers if played at a high volume, so please use
caution.
1 2 34
76 5