Filter
Top Products
133
Voice Mode
■ Wet Level
Sets the output level for the signal that is affected by
the flanger. You can adjust the FDSP (Flange)
balance by combining this parameter and the Dry
Level below.
❏ Settings: –64~0~+63
■ Dry Level
Sets the output level for the original input signal.
❏ Settings: –64~0~+63
■ Pan
The same as the one in the EP Pickup. See page 126
for information.
06: Phaser
Phaser lets you get phasing effect for each note. The
original input signals and the shifted phase signals
obtained by passing an all pass filter are mixed together
to produce dips and their feedbacks of the repeated
delay produce peaks. The frequencies of the dips and
peaks can be changed by modulating the factor of the
all pass filter using LFO and/or EG. This allows you to
get special effects by synchronizing the phase-shift to
the pitch frequencies correctly. The LFO is set for all
notes at one time while the EG can be set for each
individual note.
An all pass filter is one type of filter that changes the
characteristics of phases. It is possible to invert the phase
at the border of a specific frequency.
The underlined items in the diagram are available as the
Destination parameters for the FDSP Controller set (page
141).
■ Pitch Coarse
Adjusts the peak frequency in semitones. A setting
of “0” produces the frequency corresponding to the
pitch of C3 = 261.63Hz.
❏ Settings: –64~0 (C3)~+63
note dependent
phase shifter
Dry
Wet
FB
EG mode
Time
Depth
Depth
Pitch coarse
Release
Speed
Input Output
APF
EG
LFO
EG
■ Decay Time
Sets the EG decay time (the time of decay from the
maximum level until reaching the sustain level).
❏ Settings: 0~127
■ Decay T.Kf (Decay Time KeyFollow)
Sets the KeyFollow for the Decay Time. This
KeyFollow function controls the decay time in
accordance with the notes played on the keyboard.
When set to a positive value, the higher the note
played on the keyboard, the shorter the decay time
becomes. When a negative value is set, the lower the
note played, the shorter the decay time becomes.
❏ Settings: –64~0~+63
■ Sustain Lvl (Sustain Level)
Sets the EG sustain level (the level to be reached
from when the note is played, still the note is held).
❏ Settings: 0~127
■ ReleaseTime
Sets the EG release time (the time from key-off until
the sound ends).
❏ Settings: 0~48
■ LFO Depth (Low Frequency Oscillator Depth)
Sets the depth of the LFO wave.
❏ Settings: 0~127
■ LFO Speed (Low Frequency Oscillator Speed)
Sets the frequency of the LFO wave. The higher the
value, the faster the speed.
❏ Settings: 1~255
■ Feedback
Sets the amount of flanger feedback. The larger the
value, the more the frequency peaks are emphasized,
resulting in pronounced sounds.
❏ Settings: –64~0~+63
■ Feedback Vel(Feedback Velocity)
Sets the velocity sensitivity for the amount of
feedback. The amount of feedback can be controlled
by the velocity at which the note played on the
keyboard.
❏ Settings: –64~0~+63
Voice/E.qx 5/21/98 11:31 AM Page 133