Filter
Top Products
Reference [Effects]
ZOOM MRS-802
105
9.
If you want to adjust the patch level (the final
volume of the patch), use the cursor up/down keys
to bring up the indication “TOTAL PAT LVL”, and
turn the dial.
The patch level can be adjusted in a range of 1 - 30.
10.
When you have finished editing, press the [EXIT]
key.
The unit returns to the patch select screen.
NOTE
Keep in mind that if you return to the patch select screen and
select another patch without first storing the patch, the
edited contents will be lost. If you want to keep the results of
your editing session, refer to the following section.
Storing an insert effect patch
A patch that you have edited can be stored in any location of
the same algorithm. You can also store an existing patch in
another location to create a copy of that patch.
1.
Press the [INSERT EFFECT] keys in the display
section, and then press the [EDIT] key.
The currently selected patch can now be edited. Perform any
editing steps that you wish to make.
2.
When editing is complete, press the [STORE] key in
the control section.
A screen for specifying the store target location appears on
the display.
3.
Turn the dial to select the store destination patch
number.
4.
To store the patch, press the [STORE] key once
more.
The patch will be stored, and the unit returns to the patch
select screen.
HINT
• Patches that you have stored are saved on the hard disk
as part of the project.
• Patch data included in an already existing project can be
loaded into the current project (
→ p. 110).
Editing the name of an insert effect
patch
This section explains how to edit the name of the currently
selected patch.
1.
Press the [INSERT EFFECT] keys which includes
the target patch. Then use the PATCH SELECT
[
Q
]/[
W
] keys or the dial to select the patch that
you want to edit.
2.
Press the [EDIT] key.
The currently selected patch can now be edited.
3.
Use the cursor left/right keys to bring up the
indication “TOTAL PAT LVL”.
4.
Repeatedly press the cursor down key to bring up
the indication “PAT NAME”.
The name of the selected patch can now be edited. The
character currently selected for editing flashes.
5.
Use the cursor left/right keys to move the flashing
position to the character you want to change, and
turn the dial to select a character.
For information on available characters, refer to page 34.
6.
Repeat step 5 as necessary to complete the new
name.
TOTAL
TOTAL
PAT LVL
PAT LVL
23
Patch number
STORE
STORE
MRS-Drv
MRS-Drv
1
TOTAL
TOTAL
PAT LVL
PAT LVL
24
PAT NAME
PAT NAME
MRS-Drv
MRS-Drv