Filter
Top Products
Reference [Other Functions]
ZOOM MRS-802
137
Switching the level meter
display type
The level meter below the display can indicate the level of
the signal before passing through the level controls/faders
(pre-fader) or after passing through the level controls/faders
(post-fader). You can change the setting as follows.
1.
From the main screen, press the [UTILITY] key in
the display section.
The utility menu appears.
2.
Use the cursor left/right keys to bring up the
indication “UTILITY SYSTEM” on the display, and
press the [ENTER] key.
The system utility menu for making various system settings
appears.
3.
Use the cursor left/right keys to bring up the
indication “SYSTEM LVL MET” on the display, and
press the [ENTER] key.
The current level meter setting will be displayed.
The setting has the following meaning.
• POST
The meters show the level of the signal after passing through
the [REC LEVEL] controls/faders (default setting).
• PRE
The meters show the level of the signal before passing
through the [REC LEVEL] controls/faders.
4.
Turn the dial to change the setting.
5.
To return to the main screen, press the [EXIT] key
several times.
Hard disk maintenance
This section describes how to test and restore the integrity of
data on the internal hard disk, and how to perform other hard
disk maintenance functions.
Basic maintenance procedure
The procedure for hard disk maintenance is the same for
most operations. The basic procedure is as follows.
1.
Turn power to the MRS-802 off. While holding
down the [CLEAR] key, turn power on again.
The MRS-802 starts up in “ROM utility mode” which serves
for performing special functions.
2.
Press the [MARK] key in the control section.
The indication “ExtFunc Select” appears on the display.
3.
Use the cursor left/right keys to select the desired
command.
The following commands are available.
• ScanDisk
Test and repair the integrity of data stored on the internal
hard disk.
•Init Fac (Factory Initialize)
Restore files and data necessary for operation such as the
system files. Data created by the user will not be erased.
•Init ALL (All Initialize)
Format the internal hard disk and then restore files and data
necessary for operation such as the system files. All existing
projects on the hard disk will be erased.
4.
Press the [ENTER] key to execute the command.
Subsequent display indications and operation steps differ for
the individual commands. See the respective section below.
UTILITY
UTILITY
TR EDIT
TR EDIT
SYSTEM
SYSTEM
FOOT SW
FOOT SW
LVL MET
LVL MET
POST
POST
ROM UTY
ROM UTY
MRS-802
MRS-802
ExtFunc
ExtFunc
<Select>
<Select>