Filter
Top Products
Reference [Creating a CD]
ZOOM MRS-802
113
11.
When writing is complete, press the [EXIT] key.
The unit returns to the condition of step 4. To add more
audio data, load the next project and repeat the above
procedure.
HINT
• When using this method, a blank gap of 2 seconds will
automatically be inserted between tracks on the disc.
• As long as the finalizing operation has not been performed,
the CD-R/RW disc cannot be played on an ordinary CD
player. (For information on how to audition an unfinalized
CD-R/RW disc, refer to page 115.)
12.
To return to the main screen, press the [EXIT] key
several times.
Recording audio data by album
This method involves creating a list for the audio CD (called
an “album”) which contains information about master tracks
from multiple projects saved on the hard disk. The CD-R/
CD-RW disc containing these master tracks is then written
in a single operation.
NOTE
Before starting the procedure described below, use the
trimming function on the master track to make sure that it
does not include unwanted blank portions at the beginning
and end.
1.
Insert a CD-R/RW disc into the CD-R/RW drive.
To newly write audio data, use a blank CD-R/RW disc or a
CD-RW disc that has been completely erased.
To add audio data, use a CD-R/RW disc that has not yet been
finalized.
2.
Verify that the correct V-takes are selected for the
master tracks of the projects to be recorded.
NOTE
Projects in which an unrecorded V-take is selected for the
master track cannot be used as source material.
3.
From the main screen, press the [CD-R/RW] key in
the display section.
The CD-R/RW menu appears.
4.
Verify that the indication “CD-R/RW AUDIO CD” is
shown on the display, and press the [ENTER] key.
The audio CD menu appears.
5.
Use the cursor left/right keys to bring up the
indication “AUDIO CD ALBUM” on the display, and
press the [ENTER] key.
In this condition, you can register projects for the album.
The indication “END OF PROJ” denotes the end of the
album list of projects. When the album display is first called
up, no project has been registered, therefore the indication
“END OF PROJ” appears.
AUDIO CD
AUDIO CD
BURN CD
BURN CD