Filter
Top Products
Reference [Other Functions]
ZOOM MRS-802
139
2.
To carry out the initialization process, press the
[ENTER] key once more.
The all initialize process starts. When it is complete, the unit
returns to the condition of step 1.
Hard disk maintenance using
supplied CD-ROM
Certain hard disk maintenance functions can be performed
using the CD-ROM supplied with the MRS-802.
■ Restoring the unit to the factory default
condition (RECOVER)
This action restores the entire hard disk of the MRS-802
(including the demo songs) to the factory default condition.
All data created by the user will be erased.
■ Factory initialize (VER UP)
This action restores the system files and other data necessary
for operation of the MRS-802.
1.
With the supplied CD-ROM inserted in the CD-R/
RW drive, turn the MRS-802 on by pressing the
[POWER] switch on the rear panel.
2.
Use the cursor left/right keys to select
“RECOVER?” (to return the unit to the factory
default condition) or “VER UP” (to perform factory
initialize) and press the [ENTER] key.
The indication “Sure?” appears for confirmation of the
action. If you wish to cancel the action, press the [EXIT]
key. When the indication “Please PowerOff” is shown, set
the [POWER] switch to OFF to turn the unit off.
3.
To carry out the action, press the [ENTER] key
once more.
The maintenance process starts. When it is complete, the
indication “Done” is shown. Remove the CD-ROM from the
drive and turn the unit off and on again.
Connecting to a computer with an
option card
If the optional USB board UIB-01/UIB-02 is installed in the
MRS-802, the internal hard disk of the MRS-802 can be
recognized by a computer, for audio data editing, project
backup etc. To make this possible, connect the computer and
MRS-802 with a USB cable and start the MRS-802 in USB
mode.
HINT
Depending on the computer and the operating system, driver
installation may be required. For details, see the on-line
manual supplied with the UIB-01/UIB-02.
1.
Verify that power to the MRS-802 is turned off.
Then connect the option board to the computer
with a USB cable.
2.
While holding down the [CLEAR] key in the control
section, turn power to the MRS-802 on.
The following screen appears on the display.
3.
Press the [AUTO PUNCH IN/OUT] key in the
control section.
The following screen appears on the display, and the MRS-
802 switches to USB mode.
When USB is activated, the computer automatically
recognizes the internal hard disk of the MRS-802 and goes
into the on-line state.
For details on operation, see the on-line manual supplied
with the UIB-01/UIB-02.
Init ALL
Init ALL
Sure?
Sure?
ROM UTY
ROM UTY
MRS-802
MRS-802
I/F
I/F
WORKING
WORKING