Filter
Top Products
Reference [Creating a CD]
ZOOM MRS-802
122
is finished, the display indication changes to “ALL SAVE
COMPLETE”.
NOTE
When a full backup spans several discs, restoring a single
project requires you to first insert the disc on which it is
saved. Be sure to note the disc number and the projects
saved on the disc on the case and label of the disc.
HINT
When the disc has been ejected, it also possible to abort the
backup operation. To do this, press the [EXIT] key while the
indication “CHANGE DISCxxx” (where xxx is the disc
number) is shown. The indication will change to “ALL SAVE
CANCEL?”. Press the [ENTER] key to terminate the process.
8.
To return to the main screen, press the [EXIT] key
several times.
Loading a project from CD-R/RW disc
To restore a project saved on CD-R/RW disc to the hard disk
of the MRS-802, proceed as follows.
1.
From the main screen, press the [CD-R/RW] key in
the display section.
The CD-R/RW menu appears.
2.
Use the cursor left/right keys to bring up the
indication “CD-R/RW BACKUP” on the display, and
press the [ENTER] key.
The display shows the backup/restore menu.
3.
Use the cursor left/right keys to bring up the
indication “BACKUP LOAD” on the display, and
press the [ENTER] key.
The indication “LOAD InsDisc1” appears on the display.
4.
Insert the CD-R or CD-RW where the project is
saved into the CD-R/RW drive.
• If project was backed up as single project
Insert disc number 1.
• If project was backed up as part of a full backup of all
projects
Insert the disc where the project is stored. (If there are
multiple discs, insert the first disc that contains data of the
desired project.)
NOTE
• Also when you have backed up all projects in a single
operation, restore is performed for single projects.
• If the backup of the project spans multiple discs, be sure
to insert the first disc that contains data of the desired
project first. If you insert another disc, the project data will
not be read correctly.
5.
Press the [ENTER] key.
The name of the project on the disc, and the number which is
to be assigned to the project are shown on the display.
HINT
When being restored to the MRS-802, an empty project
number is automatically assigned to the project. Even if a
project with the same name already exists on the hard disk,
it will not be overwritten.
6.
To check the name of the directory from which the
project will be read, press the cursor down button.
The display shows the directory name.
Press the cursor up key to restore the original display.
BACKUP
BACKUP
SAVE
SAVE
LOAD
LOAD
InsDisc1
InsDisc1
LOAD
LOAD
PRJ012
PRJ012
7
Project number
to be assigned
Project name
DirName
DirName
PROJ012
PROJ012
7
Directory name