Filter
Top Products
Reference [Phrase Looping]
ZOOM MRS-802
66
7.
Turn the dial to select the desired phrase loop
number, and press the [ENTER] key.
Phrase loops can be created from 1 - 10. The name LOOP01
- LOOP10 is assigned to the respective loop.
When you press the [ENTER] key, the display changes to
the loop input screen.
8.
Use the status keys and [SOLO] key in the fader
section to input the formula for creating the loop.
For information on the FAST entry procedure, refer to page
64.
9.
When formula input is completed, press the
[ENTER] key.
The following screen appears on the display. This screen lets
you select whether to match phrase playback to the rhythm
section measure.
10.
Turn the dial to select one of the following
methods.
• ADJUST OFF
When you select this setting, the selected phrase is played
continuously, independent of the rhythm song bar lines and
tempo. (This is the default setting.)
• ADJUST BAR
When you select this setting, phrase playback start is aligned
to the measure start of the rhythm song. If one measure of
the phrase (phrase playback range divided by number of
measures specified by MEAS X parameter) is longer than
one measure of the rhythm song, the phrase is switched
when the number of measures specified by the MEAS X
(→ P.61) parameter has played, without waiting for the end
of the phrase. If one measure of the phrase is shorter than
one measure of the rhythm song, there will be a blank until
the measure where playback switches to the next phrase.
• ADJUST BAR & LEN
When you select this setting, the phrase length is adjusted so
that the measures of the rhythm song and the phrase are
matched. (Pitch will not change.)
NOTE
• When selecting ADJUST BAR or ADJUST BAR & LEN,
verify that the MEAS X parameter for each phrase is set to
a suitable number of measures. If the setting is
inappropriate, the rhythm song and phrase will not
synchronize properly.
• If the compression/stretch ratio exceeds a certain range,
the result will not be as intended. In this case, the
indication “Out of range” appears during processing.
11.
Press the [ENTER] key.
The indication “CREATE SURE?” appears on the display.
12.
To carry out the phrase loop creation process,
press the [ENTER] key once more.
The phrase loop is created. When the process is completed,
the display reverts to the condition of step 2.
0+(1+2)x
0+(1+2)x
8
ADJUST
ADJUST
OFF
OFF
3-1 4-12-11-1
(measure - beat)
Phrase A Phrase B
3-1 4-12-11-1
(measure - beat)
Phrase A
(MEAS x02)
Phrase B
(MEAS x01)
3-1 4-12-11-1
(measure - beat)
Phrase A
(MEAS x02)
Phrase B
(MEAS x01)