Filter
Top Products
Reference [Creating a CD]
ZOOM MRS-802
123
7.
Turn the dial to select the project to load, and press
the [ENTER] key.
The indication “LOAD SURE?” appears on the display.
8.
To execute the load operation, press the [ENTER]
key. To cancel, press the [EXIT] key instead.
When you press the [ENTER] key, the project data are read
from the disc and loaded to the hard disk. When the
operation is finished, the display indication changes to
“LOAD COMPLETE”.
If the backup spans multiple discs, the disc will be
automatically ejected when the data have been loaded, and
the following message appears on the display.
9.
When the above message appears, insert the next
CD-R/RW disc, and press the [ENTER] key.
The load operation resumes. If more than two discs are
required, the above steps will be repeated. When the load
operation is finished, the display indication changes to
“LOAD COMPLETE”.
NOTE
If the backup of the project spans multiple discs, be sure to
insert the discs in the correct order. Otherwise the project
data will not be read correctly.
HINT
When the disc has been ejected, it is also possible to abort
the load operation. To do this, press the [EXIT] key while the
indication “CHANGE DISCxxx” (where xxx is the disc
number) is shown. The indication will change to “LOAD
CANCEL?”. Press the [ENTER] key to terminate the process.
10.
To return to the main screen, press the [EXIT] key
several times.
CHANGE
CHANGE
DISC002
DISC002