Filter
Top Products
Reference [Effects]
ZOOM MRS-802
109
Storing a send/return effect patch
A patch you have edited can be stored in any location of the
same send/return effect. You can also store an existing patch
in another location to create a copy of that patch.
1.
Press the [REVERB] key or [CHORUS/DELAY] key
in the effect section, and then press the [EDIT] key.
The currently selected patch can now be edited. Perform the
necessary steps for editing.
2.
When editing is complete, press the [STORE] key in
the control section.
A screen for specifying the store target location appears on
the display.
3.
Turn the dial to select the store destination patch
number.
4.
Press the [STORE] key once more.
The patch will be stored, and the unit returns to the patch
select screen.
HINT
• Patches that you have stored are saved on the hard disk
as part of the project.
• Patch data included in an already existing project can be
loaded into the current project (
→ p. 110).
Editing the name of a send/return
effect patch
This section explains how to edit the name of the patch that
is currently selected for a send/return effect.
1.
Press the [REVERB] key or [CHORUS/DELAY] key
in the effect section.
If necessary, use the PATCH SELECT [Q]/[W] keys or turn
the dial to select the patch whose name you want to edit.
2.
Press the [EDIT] key, and repeatedly press the
cursor down key to bring up the indication “PAT
NAME”.
The name of the selected patch can now be edited. The
character currently selected for editing flashes.
3.
Use the cursor left/right keys to move the flashing
position to the character you want to change, and
turn the dial to select a character.
For information on available characters, refer to page 34.
4.
Repeat step 3 as necessary to complete the new
name.
5.
To confirm the new name, press the [STORE] key in
the control section twice.
The new name is stored, and the unit returns to the patch
selection screen.
Store
Store
DeepCho
DeepCho
7
PAT NAME
PAT NAME
DeepCho
DeepCho