Filter
Top Products
Reference [Projects]
ZOOM MRS-802
127
HINT
It is also possible to erase the currently loaded project. In this
case, the lowest-numbered project will automatically be
loaded after the erase operation has been completed.
Editing the project name
This lets you edit the name of the currently loaded project.
1.
Refer to steps 1 - 2 of “Basic procedure” to bring
up the indication “PROJECT NAME” on the display.
Then press the [ENTER] key.
The current project name is shown on the display.
2.
To edit the name, use the cursor left/right keys to
move the flashing position to the character you
want to change, and turn the dial to select a
character.
For information on available characters, refer to page 34.
To return to the main screen after editing the name, press the
[EXIT] key.
Protecting/unprotecting a project
This operation lets you write-protect the currently loaded
project or turn previously enabled protection off. When
protect is ON, the following operations will be impossible.
• Deleting a project
• Editing or recording on the recorder
• Changing the V-take
• Editing a patch (including module on/off)
• Recording or editing a rhythm pattern or rhythm song
• Saving scenes, making marker settings, etc.
1.
Refer to steps 1 - 2 of “Basic procedure” to bring
up the indication “PROJECT PROTECT” on the
display. Then press the [ENTER] key.
The screen for setting the protect status to ON/OFF is shown
on the display.
2.
Turn the dial to select ON (write-protect enabled)
or OFF (write-protect disabled).
When write-protect is ON for a project, a lock symbol is
shown to the right of the project number.
A change in the protect status becomes active immediately.
To return to the main screen, press the [EXIT] key several
times.
NOTE
If a project is loaded for which write-protect is not enabled,
and you select another project, the current project’s mix
settings will be overwritten, because the existing project is
automatically saved on the hard disk before loading the new
project. If you do not want a completed mix to be changed
further, it is recommended to set write-protect to ON.
HINT
The various track parameters such as EQ and panning can
be adjusted also when the project is protected (but the
settings will not be stored).
PRJ NAME
PRJ NAME
PRJ010
PRJ010
PRJ PRT
PRJ PRT
OFF
OFF
PRJ 008
PRJ 008
PRJ008
PRJ008
Lock symbol