Filter
Top Products
88
MIXER MODE
However, it is also possible to navigate the 'channel' window (i.e. pan, level, EQ, FX param-
eters) using the CURSOR keys or Q5. For the field that is selected by the cursor:
You can set precise values from the numeric keypad or using the DATA +/- keys.
You can also set values using the DATA ENTRY Q-Link control on Q6.
In the EQ Channel page, the Q-LINK parameters on the right of the page are as follows:
INPUT SOURCE If the selected channel is an Input channel, Q1 selects the input source.
The choices are:
ADC 1-12 FX 1 L
Digital In LFX 1 R
Digital In RFX 2 L
Aux In L FX 2 R
Aux In R FX 3 L
2-Track L FX 3 R
2-Track R FX 4 L
ADAT 1 - 8 FX 4 R
ADAT 9-24 METRO
In this way, you can patch any analogue or digital audio source to any input.
RECORD SOURCE
If the selected channel is a Track channel, Q1 selects the Disk Record source.
The choices are the same as the Input Channel's Input sources, plus:
INP 1-12 Stereo L
Group 1-8 Stereo R
- - - - - (no assignment)
INPUT SOURCE If the selected channel is a stereo FX Return channel, Q1 selects the in-
put source pair.
The choices are:
FX1 L+R Digital In L+R
FX2 L+R Aux In L+R
FX3 L+R 2-Track L+R
FX4 L+R ADAT 1+2
ADC1+2 ADAT 3+4
ADC3+4 ADAT 5+6
ADC5+6 ADAT 7+8
ADC7+8 ADAT 9+10
ADC9+10 ... up to ...
ADC11+12 ADAT 23+24
PHASE INVERT Q2 inverts the phase of the channel.
This is available only for Mono Input and Track Channels.
ATTENUATION
Q3 is simple attenuator to compensate for any excessive gain boosts in the EQ.
This is available only for Mono Input and Track Channels.
METER
Q4 allows you to set where in the audio chain you will view the meter shown
to the right of the fader. The options are PRE-EQ, PRE-FADE and POST-FADE.
This is available only for Mono Input, Track and FX Return Channels.
v1.6 Operator’s Manual