Filter
Top Products
AUDIO SETUP
177
AUDIO SETUP
If you select AUDIO SETUP [F3/F4], you will see this screen:
The parameters are:
SOURCE [Q1]
Here you may select 2-TRACK L/R, DIGI IN L/R or AUX IN as the
physical inputs for the 2-Track Source.
LEVEL [Q2]
Here you can set the level of the incoming 2-track source.
2-TRACK SENS [Q3]
Here you can set the input sensitivity of the 2-track source.
The options are:
HIGH Maximum input level is + 4dB
LOW Maximum input level is +13dB
MPLP CONNECTION [Q4]
Here you can set the operation of the lightpipe I/O.
The MPLP (Multi-Purpose LightPipe - the optical connectors) can be switched
between SPDIF (Stereo) or ADAT (8-Channel).
When MPLP is set to ADAT, the optical I/O connectors are both used for 8-
channel ADAT signals (ADAT 1..8), while the RCA SPDIF I/O connectors are
used for Stereo SPDIF signals (DIGI IN L/R and stereo DIGITAL OUTPUT).
However, when MPLP is set to SPDIF, the optical I/O connectors are both
used for Stereo SPDIF signals (DIGI IN L/R and stereo DIGITAL OUTPUT).
In this case, the SPDIF Input RCA connector is disabled and the SPDIF Out-
put RCA connector is used for Stereo SPDIF ouptut (same signal as the optical
output connector).
SPDIF FORMAT [Q5]
Selects the stereo digital output format The format can be switched be-
tween CONSUMER and PROFESSIONAL. Note that this affects the RCA
phono output and the MPLP output when it is set to SPDIF.
As the name implies, CONSUMER should be used with 'consumer' prod-
ucts such as CD players, etc.. PROFESSIONAL should be used with more
professional equipment that use the AES/EBU format of digital audio.
v1.6 Operator’s Manual