Filter
Top Products
VTrak 15110 User Manual
24
Plug the power cords into the power connections on both power supplies. Use
the retaining bails to hold the power cords in place and prevent an accidental
disconnection.
Turn both power supplies on.
When the power is switched on, the LEDs on the front of the VTrak will light up.
Figure 12.VTrak 15110 Displays
When boot-up is finished and the VTrak is functioning normally:
• Controller LED blinks green once per second for five seconds, goes dark for
five seconds, then blinks green once per second for five seconds again.
• Power, FRU and Logical Drive LEDs display green continuously.
• SCSI LEDs flash green if there is activity on that channel.
There are two LEDs on each Drive Carrier. They report the presence of power
and a disk drive, and the current condition of the drive.
Figure 13.VTrak 15110 Disk Carrier LEDs
Power
SCSI-2
Activity
FRU
Status
Disk Array
Status
SCSI-1
Activity
Controller
Heartbeat
Disk Status
Power/
Activity