Filter
Top Products
43
Chapter 3: Setup
• VTrak Setup with WebPAM PRO (below)
• VTrak Setup with the CLU (page 57)
After installation, the next step is to configure VTrak. You can do this with
WebPAM PRO or the Command Line Utility (CLU), whichever you prefer.
This Chapter only deals with basic functions needed to setup a new VTrak. For a
full discussion of VTrak functions,refer to WebPAM PRO on page 65 and the CLU
on page 133.
VTrak Setup with WebPAM PRO
Set up with WebPAM PRO consists of the following steps:
1. Log-in to WebPAM PRO (below)
2. Add a Subsystem (VTrak) (page 46)
3. Access a Subsystem (VTrak) (page 46)
4. Create a Disk Array (page 48)
5. Create a Logical Drive (page 54)
6. Assign a SCSI Target ID (page 55)
7. Log-out of WebPAM PRO (page 56)
Log-in to WebPAM PRO
1. Launch your Browser.
2. In the Browser address field, type in the IP address of the PC/Server where
you installed WebPAM PRO, as explained below. Do not type the VTrak’s IP
address.
If you did not choose the External Security option during WebPAM PRO
installation, use the Regular connection.
If you chose the External Security option during WebPAM PRO installation,
use the Secure connection.
Regular Connection
• WebPAM PRO uses an HTTP connection. . . . . . . . . . . . . . . . .http://
• Enter the PC/Server’s IP address . . . . . . . . . . . . . . . 192.168.10.46
• Enter the Port number . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . :8080
• Add to launch WebPAM PRO . . . . . . . . . . . . . . . . . . . . . . . /promise
Together, your entry looks like this:
http://192.168.10.46:8080/promise