Filter
Top Products
127
Recording Songs
When you use realtime recording, all of your sequencer data will
normally be recorded. If you want to avoid recording a specific type
of data, you can turn its Recording Select setting “OFF.”
1.
Press [ ].
2.
Press [F5 (REC SELECT)].
The Recording Select window appears.
fig.RecSelect
3.
Press [CURSOR] to select the sequencer data (MIDI
messages) that will be recorded.
4.
Use the VALUE dial or [INC] [DEC] to add a check mark (
✔
).
The message will be recorded if you assign a check mark (
✔
),
and will not be recorded if you remove the check mark.
• [F4 (ALL ON)]: All of the sequencer data will be recorded.
• [F5 (ALL OFF)]: No sequencer data will be recorded.
5.
Press [F6 (CLOSE)] to close the Recording Select window.
Realtime Erase is a function that erases unwanted data during
realtime recording. This is particularly convenient during loop
recording, since it lets you erase data without stopping recording.
* Realtime Erase can be executed only if the Recording Mode is set to
“MIX.”
1.
Begin realtime recording (p. 124).
The Realtime Rec Control window appears.
2.
Press [ERASE/UNDO].
The Realtime Erase window appears.
fig.RealErase
3.
Erase unwanted data.
• To erase all data (except for Pattern Call messages), press [F4
(KBD ALL)]. Data will be erased for as long as you hold down
the button.
• To erase notes of a specific key (pad), hold down that key (pad).
Data for that note will be erased for as long as you hold down
that key.
• To erase notes of a specific key range, hold down the top and
bottom keys of that range. Data for that range will be erased for
as long as you hold down those keys.
4.
Press [F6 (CLOSE)] to close the Realtime Erase window.
You will return to the normal recording state.
* You can also erase the data of a specific channel.
When recording arpeggios in real time, you can synchronize the
arpeggio with the sequencer start/stop timing.
For details, refer to
Arp/Rhythm Sync Switch
(p. 200).
The Rehearsal function lets you temporarily suspend recording
during realtime recording. This is convenient when you want to
audition the sound that you will use next, or to practice the phrase
that you will record next.
1.
Begin realtime recording (p. 124).
The Realtime Rec Control window appears.
2.
Press [F6 (REHEARSAL)] or [ ].
The [ ] indicator will blink, indicating that you are in
rehearsal mode. In this state, nothing will be recorded when
you play the keyboard.
fig.Rehearsal
3.
To return to record mode, press [F6 (REHEARSAL)] or [ ]
once again.
Selecting the Sequencer Data that
will Be Recorded (Recording Select)
MIDI Message Explanation
Note
Represent notes.
Control Change Apply various effects such as modulation or
expression.
Program Change Select sounds.
System Ex Used to make settings unique to the
Fantom-Xa, such as sound parameters.
Channel After Apply aftertouch to an entire MIDI channel.
Poly After Apply aftertouch to individual keys.
Pitch Bend Change the pitch.
Erasing Unwanted Data While You
Record (Realtime Erase)
Recording Arpeggios Aligned to
the Measures of the Sequencer
Auditioning Sounds or Phrases
While Recording (Rehearsal
Function)
Fantom-Xa_e.book 127 ページ ２００４年１０月２２日 金曜日 午後２時３分