Filter
Top Products
27
Basic Operation of the Fantom-Xa
A single screen or window displays multiple parameters or items for
selection. To edit the setting of a parameter, move the cursor to the
value of that parameter. To select an item, move the cursor to that
item. When selected with the cursor, a parameter value or other
selection is highlighted.
fig.CursorScreen
Move the cursor with the , , and (cursor buttons).
fig.CURSOR
: moves the cursor up.
: moves the cursor down.
: moves the cursor to the left.
: moves the cursor to the right.
• If you hold down one cursor button while you also press the
cursor button for the opposite direction, the cursor will move
more rapidly in the direction of the first-pressed cursor button.
• When the cursor is displayed, pressing [ENTER] will sometimes
display a list of the available choices for that parameter. This is
convenient when you want to see what your choices are.
To change the value, use the VALUE dial or the [INC] [DEC]
buttons.
fig.VALUE
In each screen of the Fantom-Xa, you can use the cursor buttons
to move the area displayed as highlighted, and modify its value.
* Each parameter has its own range of possible values, so you cannot set
any value smaller than the minimum value or greater than the
maximum value.
Turning the VALUE dial clockwise increases the value,
counterclockwise decreases the value.
• Holding down [SHIFT] as you move the VALUE dial increases
value increments so you can make large value changes faster.
Pressing [INC] increases the value, and [DEC] decreases it.
• Keep the button pressed for continuous adjustment.
• For faster value increases, keep [INC] pressed down and press
[DEC]. For decreasing value faster, keep [DEC] pressed down
and press [INC].
• If you press [INC] or [DEC] while holding down [SHIFT], the
value increments will get bigger.
In some cases when the cursor is located at an input location, you
can press [ENTER] to see a list of parameter values. For some of
these lists, you can use the pads to input or specify the value.
1.
Press [TRIGGER] and [CATEGORY] simultaneously so both
buttons are lit.
You can use the pads to input or specify the value.
When inputting a numerical value
PAD [0]–[9]:
Input numerals 0–9
[SHIFT]:
Cancels the numeral you input
fig.PadNumber
When inputting directly
Pressing a pad will directly input the corresponding value.
From the top, the items in the list correspond to pads [0]–[9].
fig.PadDirect
Moving the Cursor
Changing a Value
Cursor
VALUE Dial
[INC] and [DEC]
Using the pads
When the cursor is located at a parameter value, press [ENTER]
to display a window where you can set the value. Use
to select a value, and then press [ENTER] to finalize the setting.
Fantom-Xa_e.book 27 ページ ２００４年１０月２２日 金曜日 午後２時３分