Filter
Top Products
142
Editing Songs
This function shifts the timing of sequencer data backward or
forward in time within a specified area in steps of 1 tick. Slight shifts
of timing can speed up or drag performance.
* When this function is executed, data that would be moved to a point
before the beginning of the song will automatically shift to the
beginning of the song. If data would be moved to a point past the end
of the song, additional new measures will be created automatically as
needed. The time signature of the newly created measures will be the
same as that of the measure immediately preceding.
For details on the settings, refer to
Basic Operation for Track
Editing
(p. 133).
fig.ShiftClock
Shifting Performance Data
Forward and Back (Shift Clock)
Parameter
Value Explanation
Track/Pattern
TRK ALL,
TRK 1–16,
TEMPO,
PTN001–100
Track(s) or pattern whose
sequencer data will be
moved in units of one tick
ALL:
Phrase tracks 1–16, the beat track, and
the tempo track
TRK 1–16:
Specified phrase track
TEMPO:
Tempo track
PTN001–100:
Specified pattern
Ch/Part ALL, Ch 1–16 MIDI channel of the data
to be shifted in time
ALL:
Shifts ticks of all sequencer data.
Ch 1–16:
Shifts the sequencer data tick of just
one specific MIDI channel.
* If you set “Track” to “TEMPO,” or if “Status” is
set to “System Exclusive,” “Tune Request” or
“Pattern Call,” this parameter will not be avail-
able.
Measure
0001– Range of measures in
which the sequencer data
will be moved in units of
one tick.
If you set “For” to
“ALL,” all measures
will be specified.
For 1–ALL
Bias -4800–4800 Amount (number of
ticks) by which the se-
quencer data will be
moved
Status ALL, Note,
Poly Aftertouch,
Control Change,
Program Change,
Channel After-
touch, Pitch Bend,
System Exclusive,
Tune Request,
Pattern Call
Type of data to be shifted
in time
* If “Track” is set to
“TEMPO,” this parame-
ter will not be available.
When “Status” is “Note” or “Poly Aftertouch”
Range Min
0 (C -)–127 (G9) Range of note numbers to
be shifted
You can also specify
the key range by press-
ing keys on the key-
board.
Range Max
When “Status” is “Control Change”
Range Min
0–127 Range of controller num-
bers to be shifted
Range Max
When “Status” is “Program Change”
Range Min
1–128 Range of program num-
bers to be shifted
Range Max
Parameter
Value Explanation
Fantom-Xa_e.book 142 ページ ２００４年１０月２２日 金曜日 午後２時３分