Filter
Top Products
50
Creating a Patch
Parameter
Value Explanation
CTRL 1–4 Sens 1–4
-63– +63 Amount of the Matrix Control’s effect that is applied
If you wish to modify the selected parameter in a positive (+) direction—i.e., a higher value, toward
the right, or faster etc.—from its current setting, select a positive (+) value. If you wish to modify the
selected parameter in a negative (-) direction—i.e., a lower value, toward the left, or slower etc.—from
its current setting, select a negative (-) value. For either positive or negative settings, greater absolute
values will allow greater amounts of change. Set this to “0” if you don’t want to apply the effect.
CTRL 1–4 Switch 1–4 OFF, ON,
REVS
Tone to which the effect is applied when using the Matrix Control
OFF:
The effect will not be applied.
ON:
The effect will be applied.
REVS:
The effect will be applied in reverse.
Fantom-Xa_e.book 50 ページ ２００４年１０月２２日 金曜日 午後２時３分