Filter
Top Products
195
Settings Common to All Modes (System Function)
[F1 (KBD)]
[F2 (PDL BND)]
System Menu [F2 (KBD/CTRL)]
Parameter
Value Explanation
Keyboard Velocity
REAL, 1–127 Velocity value that will be transmitted when you play the keyboard
REAL:
Actual keyboard velocity will be transmitted.
1–127:
A fixed velocity value will be transmitted regardless of how you play.
Touch Sens LIGHT, MEDIUM,
HEAVY
Keyboard’s touch
LIGHT:
Light weight synthesizer keyboard like
MEDIUM:
Standard
HEAVY:
Acoustic piano simulation
Parameter
Value Explanation
Pedal
Control Pedal As-
sign
CC01–31, 33–95,
BEND UP,
BEND DOWN,
AFTERTOUCH,
OCT UP,
OCT DOWN,
START/STOP,
PUNCH IN/OUT,
TAP TEMPO,
PROG UP,
PROG DOWN,
FAVORITE UP,
FAVORITE DOWN,
ARP SW,
RHY START/STOP,
CHORD SW,
LOOP
Function of the pedal connected to the PEDAL CONTROL jacks
CC01–31, 33–95:
Controller numbers 1-31, 33-95
BEND UP:
The pitch will rise in semitone steps (maximum 4 octaves) each time you press the
pedal.
BEND DOWN:
The pitch will fall in semitone steps (maximum 4 octaves) each time you press
the pedal.
AFTERTOUCH:
Aftertouch
OCT UP:
Each pedal press raises the key range in octave steps (up to 3 octaves higher).
OCT DOWN:
Each pedal press lowers the key range in octave steps (up to 3 octaves lower).
START/STOP:
The sequencer will start/stop.
PUNCH IN/OUT:
Manual punch-in/out recording will start/stop.
TAP TEMPO:
Tap tempo (a tempo specified by the interval at which you press the pedal).
PROG UP:
The next sound number will be selected.
PROG DOWN:
The previous sound number will be selected.
FAVORITE UP:
The favorite patch/performance of the next number or bank will be selected.
FAVORITE DOWN:
The favorite patch/performance of the previous number or bank will be
selected.
ARP SW:
Arpeggio/Rhythm function on/off
RHY START/STOP:
Rhythm pattern playback on/off
CHORD SW:
Chord memory function on/off
LOOP:
Loop play on/off
Control Pedal Polar-
ity
STANDARD,
REVERSE
Selects the polarity of the pedal.
On some pedals, the electrical signal output by the pedal when it is pressed or released is the
opposite of other pedals. If your pedal has an effect opposite of what you expect, set this pa-
rameter to “REVERSE.” If you are using a Roland pedal (that has no polarity switch), set this
parameter to “STANDARD.”
Hold Pedal Polarity STANDARD,
REVERSE
Continuous Hold
Pedal
OFF, ON Determines whether the HOLD PEDAL jack will provide support for half-pedaling (ON), or not
(OFF).
When this is set to support use of half-pedaling techniques, you can then connect an optional
expression pedal (DP-8, etc.), and employ pedal work to achieve even finer control in perfor-
mances in which piano tones are used.
Pitch Bend
Bender and Modula-
tion Part Select
KBD, PAD Part controlled by the Pitch Bend/Modulation lever
Fantom-Xa_e.book 195 ページ ２００４年１０月２２日 金曜日 午後２時３分