Filter
Top Products
AW2400 Owner’s Manual
Displaying the mix parameters for individual channels
Channel Operation
106
12
1 INITIALIZE button
Initializes all parameters for the currently displayed chan-
nel.
B Channel Pair Indicator
Indicates whether the displayed channel is part of a pair or
not. You can also move the cursor to this indicator and
press the [ENTER] key to turn pairing on or off.
C PHASE button, GATE button
• PHASE button..... Switches the phase (polarity) of the
input signal. Move the cursor to this
button and press the [ENTER] key
to switch between normal (N : NOR-
MAL) and reverse (R : REVERSE)
polarity.
•GATE button (input channels only)
................. Move the cursor to this button and
press the [ENTER] key to turn the
gate for that channel on or off. Refer
to “Using the Gates” on page 151 for
details.
D ATT button, EQ button
•ATT button........... Move the cursor to this knob and
use the [DATA/JOG] dial or [INC]/
[DEC] keys to adjust the attenuation
as required (range: -96–+12dB).
This capability can be used to atten-
uate the pre-EQ signal level to pre-
vent clipping in the EQ stage.
• EQ button............ Move the cursor to this button and
press the [ENTER] key to turn the
EQ for that channel on or off. Refer
to “4-band EQ” on page 149 for
details.
■ Stereo output channel
A
K
D
F
G HE
■ Bus master channels 1, 2
A
K
D
F
GE
■ AUX send master channels 1–4
A
K
D
F
GE
B
■ Effect send master channels 1–4
A
K
F
E
• Pressing the [F1] key while holding the Display section [SHIFT]
key has the same effect as the INITIALIZE button.
HINT