Filter
Top Products
AW2400 Owner’s Manual
Direct recording and Mixed recording
Track recording
54
6
Use the following procedure to set up the patching so you
can mix and record the signals from multiple instruments/
mics connected to [MIC/LINE INPUT] jacks 1–8 to one
or more tracks.
1
Lower the [STEREO] fader to the – ∞ posi-
tion.
2
Referring to “Connection and Setup” on
page 37, connect your instruments and/or
microphones and set up the input levels.
3
Call the RECORD screen Mixed page by
either pressing the Quick Navigate section
[RECORD] key as many times as necessary,
or by pressing the [F2] key after pressing
the [RECORD] key.
Via the RECORD screen Mixed page you can patch
multiple input channels to either of the AW2400’s ste-
reo buses (Bus1 and Bus2), allowing mixed signals to
be assigned to up to four tracks.
4
Check that “AD1–8” appears in the input
select field on the left side of the page. If a
different input source is selected move the
cursor to the input select field and use the
[DATA/JOG] dial or [INC]/[DEC] keys to
select “AD1–8”.
5
Press the [INPUT SEL] key for the input
channel to which your instrument/micro-
phone is connected.
The currently selected [INPUT
SEL] key will light orange, and
that input channel will be selected
for operation.
The symbol for the correspond-
ing input channel will be high-
lighted in the screen, and a line
will appear indicating that this
channel is connected to the bus.
6
Repeatedly press the same [INPUT SEL]
key to select the bus to which you want to
send the signal from that input channel.
Each time you press the [INPUT SEL] key the screen
will change as follows.
7
Use the same procedure to specify other
input channels as recording sources as
required.
Assigning input signals to tracks
(Mixed recording)
• Refer to page 102 for more details on patching for mixed record-
ing.
HINT
Tracks
Input channels
Input select
AOff
To
A
E
Bus 2 L/R
On
BBus 1 L/R
On
CBus 1 L
On
FBus 2 L
On
GBus 2 R
On
DBus 1 R
On
• Input channels that are patched to Bus1 or Bus2 will be auto-
matically disconnected from the stereo bus and their signal
will not be output via the [STEREO OUT] or [MONITOR OUT]
jacks (the signals being recorded can be monitored via the
track channel being recorded).
• When an input is disconnected from Bus1 or Bus2, that input
is automatically re-patched to the stereo bus.
•You can also switch to Bus1/Bus2 by moving the cursor to the
symbol of the desired input channel and pressing the
[ENTER] key.
HINT
•To select the [DIGITAL STEREO IN] connector as the record
source you will need to assign the [DIGITAL STEREO IN]
connector to an adjacent pair of odd- and even-numbered
tracks via the DIGITAL IN field (1.2–15.16). See page 102 for
details.
NOTE