Filter
Top Products
Applying Effects via Send and Return
117
AW2400 Owner’s Manual
Effects
14
The procedure for applying effects 1–4 via the effect sends and returns is described below.
1
Referring to the instructions in “Recalling
Effect Library settings” on page 116, recall
an effect library preset that is based on the
effect you want to use.
2
Make sure that the Selected Channel sec-
tion [EFFECT] key is engaged and its indi-
cator is lit.
3
Make sure that the EFFECT screen selected
in step 1 is showing.
Selected Channel knobs 1–4 correspond to EFFECT
screens 1–4. Press the appropriate knob to call the
desired screen.
4
To adjust the send level to an effect bus
start by pressing the Display section [F1]
key to call the FX Input page, or the [F2] key
to call the FX Track page.
The FX Input page allows adjustment of the input
channel send levels, while the FX Track page allows
adjustment of the track channel send levels. The items
included in the FX Input and FX Track pages are as
follows.
● EFFECT screen FX Input page
1 INPUT field
Allows adjustment of the effect send levels for input
channels 1–16. You can also select the point from
which the send signal is derived via the PRE/POST
button below each knob.
● EFFECT screen FX Track page
1 TRACK field
Allows adjustment of the effect send levels for track
channels 1–24. You can also select the point from
which the send signal is derived via the PRE/POST
button below each knob.
5
Move the cursor to an effect send knob and
use the [DATA/JOG] dial or [INC]/[DEC] keys
to set the effect send level.
Applying Effects via Send and Return
• An effect that has been inserted into a channel cannot be simultaneously used with the effect
sends and returns.
• All effects can be used via the effect sends and returns in new song with the initial default set-
tings. If an effect has been inserted in a specific channel it can be removed and freed for use
with the sends and returns as described in “Inserting an Effect Into a Channel” on page 119.
NOTE
A
A
• When the [EFFECT] key is lit you can repeatedly press a
Selected Channel knob to sequentially select the related
effect pages.
• By pressing the [F1] or [F2] key while holding the Display sec-
tion [SHIFT] key you can set all channels within the display to
PRE ([F1]) or POST ([F2]) with one operation.
HINT
• By moving the cursor to an effect send knob and pressing the
[ENTER] key the effect send for that channel can be turned
off or on.
• Effect send levels can also be adjusted while the [EFFECT]
key is engaged by pressing the [INPUT SEL] or [SEL] key for
the target channel and using Selected Channel knobs 1–4 to
adjust the send level to the corresponding effect processor.
HINT