Filter
Top Products
AW2400 Owner’s Manual
Applying Effects via Send and Return
Effects
118
14
6
Move the cursor to the PRE/POST button
and press the [ENTER] key to switch the
location from which the signal will be sent
from each channel to the Effect buses.
Select PRE for pre-fader or POST for post-fader send.
7
To adjust the effect mix balance (the bal-
ance between the effect and direct signals),
press the [F3] key.
The EFFECT screen FX Edit page will appear.
8
Use MIX BALANCE field knob to adjust the
balance between the direct and effect sig-
nals.
When applying an effect via the effect sends and
returns the effect mix level is usually set to 100%
(effect sound only).
9
The effect send master levels can be
adjusted via faders 9–12 after pressing the
Layer section [MASTER] key.
When the MASTER mixing layer is selected faders 9–
12 control the master send levels for effects 1–4,
respectively. You can view and edit the various param-
eters for each master send channel by pressing [SEL]
key 9–12 and then calling the CH VIEW screen View
page.
10
To adjust the effect return levels press the
Layer section [IN 1-8] or [IN 9-16] key, and
use faders 9–12 to adjust the correspond-
ing return levels.
When mixing layer IN 1-8 or IN 9-16 is selected fad-
ers 9–12 control the return levels for effects 1–4,
respectively. You can view and edit the various param-
eters for each return channel by pressing [SEL] key 9–
12 and then calling the CH VIEW screen View page.
• The effect parameters can be edited as required via the FX
Edit page. Refer to “Editing Effects” on page 121 for details.
HINT
• See “Displaying the mix parameters for individual channels”
on page 105 for details.
HINT