Filter
Top Products
108
Depending on the selected effects the SY85 effect system can have up to four
separate output levels that are adjusted by the parameters provided in this screen.
3: OUTPUT LEVEL
[VOICE] → [EFFECT EDIT] → [MENU] → 3:Output Level → [ENTER/YES]
1a, 1b, 2a, and 2b (Effect output levels)
Range: 0 … 100
Controls: [CS3], [CS4], [CS7], [CS8], [-1] [+1], Dial
The [CS3] and [CS4] sliders adjust the output levels of the effect 1 “1a”
and “1b” stages, respectively, while the [CS7] and [CS8] sliders adjust the
output levels of the effect 2 “2a” and “2b” stages. A setting of “0” turns output
from the corresponding effect stage off, while a setting of “100” produces
maximum output level.
If the selected effect is a “single” type, then only the “1a” or “2a” output
level is available. If it is a “cascade” type, then only the “1b” or “2b” output
level is available. Both the “1a” and “1b” or “2a” and “2b” levels are available
only if the selected effect is a “dual” type. The type of the effects currently
selected for the effect 1 and effect 2 processors are shown in parentheses on
the bottom line of the display. See page 254 for details on the effect stages and
the SY85 effect system in general.
If a controller is assigned to any of the output level parameters (page 110),
an inverse “c” will appear to the right of the parameter.
VOICE EDIT MODE / EFFECT EDIT
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8