Filter
Top Products
150 SONG EDIT MODE / MULTI EDIT
In a multi setup, interesting stereo effects can be produced by placing the output
from different voices at different locations in the stereo sound field. The parameters
in this screen determine the position in the stereo sound field in which the sound
from each active voice will be heard (left to right).
3: PAN
[SONG] → [MULTI EDIT] → [MENU] → 3:Pan → [ENTER/YES]
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
Pan
Range: -31 … +31, vce
Controls: [SHIFT] + [ ]/[ ], [CS1] … [CS8], [-1] [+1], Dial
Only eight voice numbers are shown on the display at one time. Use the
PAGE [ ] and [ ] keys while holding the [SHIFT] key to switch between
multi instruments “1 … 8” and “9 … 16”. The currenty selected group of
voices is indicated on the upper display line.
Use the [CS1] through [CS8] sliders to adjust the pan positions of voices 1
through 8 or 9 through 16, respectively. The name of the currently selected
voice is shown in the upper right corner of the display. Voices that are turned
off are indicated by “---” on the display. Minus values represent panning to the
left, and positive values represent panning to the right. “0” positions the sound
of the selected layer in the center of the stereo sound field. The next setting
above “+31” is “vce.” When “vce” is selected the preset pan position for the
selected voice or performance combination is used. The upper line of the dis-
play also shows a graphic representation of the stereo sound field with “L”
representing “left” and “R” representing “right.” As you change the pan value
the vertical bar will appear at the corresponding position on the graphic dis-
play.