Filter
Top Products
40
These parameters determine turn the “dry lines” (i.e. the signal paths which by-
passes each effect processor) on or off, determining whether any dry signal output
can occur at OUTPUT 1 and OUTPUT 2.
3: LAYER DRY OUTPUT SELECT
[PERFORMANCE] → [EFFECT EDIT] → [MENU] → 3:Layer Dry Out Select → [ENTER/YES]
Layer
Range: A, B, C, D
Controls: [CS2], PROGRAM [1] … [4], [-1] [+1], Dial
Selects the layer to be edited. The name of the voice assigned to the se-
lected layer is shown between parentheses on the upper line of the display.
Dry1
Range: off, on
Controls: [CS6], [-1] [+1], Dial
Turns the “dry line” bypassing the EFFECT 1 signal processor on or off.
When this parameter is turned “off,” the “WET:DRY BALANCE” parameters
(page 42) have no effect.
Dry2
Range: off, on
Controls: [CS7], [-1] [+1], Dial
Turns the “dry line” bypassing the EFFECT 2 signal processor on or off.
When this parameter is turned “off,” the “WET:DRY BALANCE” parameters
(page 42) have no effect.
PERFORMANCE EDIT MODE / EFFECT EDIT
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8