Filter
Top Products
222 UTILITY MODE / MIDI
Initiates MIDI bulk transmission of the selected voice, multi-play, and/or system
data.
BULK DUMP
[UTILITY] → [MIDI]
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
Type
Range: all, synth all, sequencer all, pattern all, 1 performance, 1
voice, 1 song
Controls: [CS3], [-1] [+1], Dial
Use [CS3] to select the type of data you want to transmit. The various data
types are as follows:
1: all All internal data.
2: synth all All synthesizer data, including setup, performance
combinations, and voices.
3: sequencer all All sequencer data, including setup, songs,and patterns.
4: pattern all All patterns.
5: 1 performance The currently selected performance combination.
6: 1 voice The currently selected voice.
7: 1 song The currently selected song, including multi data.
Press [ENTER/YES] to begin the bulk dump procedure. The following
confirmation display will appear:
Press [ENTER/YES] again to confirm that you want to go ahead with the
bulk dump operation, or press [EXIT/NO] to cancel.
When the data has been transmitted, “Completed!” will appear briefly on
the display.
This function is useful for transferring synthesizer, sequencer, and/or system
data from one SY85 to another. If the MIDI OUT of the transmitting SY85 is
connected to the MIDI IN of the receiving SY85 via a MIDI cable, the receiv-
ing unit will automatically receive and load the data as long as its BULK
RECEIVE PROTECT (page 214) function is turned “off” and it is set to the
same device number as the transmitting SY85. Another possibility is to transfer
the data to an external MIDI bulk data storage device for long-term storage.