Filter
Top Products
43PERFORMANCE EDIT MODE / EFFECT EDIT
These parameters determine the mix level between each effect send and the output
of the preceding effect stage. Refer to the section beginning on page 254 for details
on the overall SY85 effect system.
6: SEND & EFFECT 2 MIX LEVEL
[PERFORMANCE] → [EFFECT EDIT] → [MENU] → 6:Mix Level → [ENTER/YES]
EF2 Mix (Effect 2 mix level)
Range: 0 … 100
Controls: [CS4], [-1] [+1], Dial
Mixes the output of the EFFECT 2 processor with that of the EFFECT 1
processor. This parameter can only be used with the “serial” effect mode is
selected. If any other mode is selected (“off” or “para”), “---” appears on the
display in place of the value.
If a controller is assigned to the EF2 Mix parameter (page 45), an inverse
“c” will appear to the right of the parameter.
Insert 1b, 2a, 2b (Insert level)
Range: 0 … 100
Controls: [CS6], [CS7], [CS8], [-1] [+1], Dial
These parameters mix the dry signal sent to the corresponding effect stage
with the output of the preceding effect stage. The higher the value the greater
mix level. If the current effect configuration does not allow one of these mix
parameters, “--” will appear in place of the mix level parameter.
If a controller is assigned to the one of these parameters (page 45), an
inverse “c” will appear to the right of the parameter.
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8