Filter
Top Products
27PERFORMANCE EDIT MODE / QUICK EDIT
These parameters allow the amplitude envelopes of the voices assigned to each
layer to be modified to some degree. The actual amplitude EG of the voices are not
affected, these “offset” values are only effective in the performance mode.
1: AMPLITUDE EG OFFSET
[PERFORMANCE] → [QUICK EDIT] → [MENU] → 1:AEG Offset → [ENTER/YES]
Use PROGRAM keys [1] through [4] (LAYER SELECT A, B, C, and D) to
select the layer to be edited.
Hold the [F1] function key (“ALL”) while editing any of the following
parameters to change its value by the same amount for all layers simultane-
ously.
R1 (Attack rate)
Range: -63 … +63
Controls: [CS3], [-1] [+1], Dial
Modifies the “R1” parameter of the voice amplitude EG — see page 60.
Plus (+) values produce a faster attack rate while minus (-) values produce a
slower attack rate.
No matter how much offset is applied, the minimum and maximum EG
attack rates cannot be exceeded.
R2,3 (Decay 1 rate)
Range: -63 … +63
Controls: [CS4], [-1] [+1], Dial
Modifies the “R2” and “R3” parameters of the voice amplitude EG — see
page 60. Plus (+) values produce a faster decay rate while minus (-) values
produce a slower decay rate.
No matter how much offset is applied, the minimum and maximum EG
decay rates cannot be exceeded.
R4 (Decay 2 rate)
Range: -63 … +63
Controls: [CS5], [-1] [+1], Dial
Modifies the “R4” parameter of the voice amplitude EG — see page 60.
Plus (+) values produce a faster decay rate while minus (-) values produce a
slower decay rate.
No matter how much offset is applied, the minimum and maximum EG
decay rates cannot be exceeded.
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8