Filter
Top Products
133
5: WET:DRY BALANCE
[VOICE] → [EFFECT EDIT] → [MENU] → 5:Wet:Dry Balance → [ENTER/YES]
The balance between the direct sound of the voice and the effect sound is a
delicate thing. Even slight changes can make a big difference to the final sound. The
parameters provided in this screen provide precise balance control.
DRUM VOICE EDIT MODE / EFFECT EDIT
Out1 Wet/Out2 Wet
Range: 0 … 100
Controls: [CS3]/[CS7], [-1] [+1], Dial
These parameters and the corresponding “Out1 Dry” and “Out2 Dry” pa-
rameters, below, work together to balance the effect (“wet”) and direct (“dry”)
signals delivered via the EFFECT 1 and EFFECT2 processors. Higher “Wet”
values produce more effect sound in relation to the direct, dry sound of the
voice.
Although the “Wet” and “Dry” parameters can be set independently, adjust-
ing one will cause the other to change so that their total is always 100(%).
If a controller is assigned to the “Out1 Wet” or “Out2 Wet” parameter
(page 136), an inverse “c” will appear to the right of the parameter.
Out2 Dry/Out2 Dry
Range: 0 … 100
Controls: [CS4]/[CS8], [-1] [+1], Dial
These parameters and the corresponding “Out1 Wet” and “Out2 Wet” pa-
rameters, above, work together to balance the effect (“wet”) and direct (“dry”)
signals delivered via the EFFECT 1 and EFFECT 2 processors, respectively.
Higher “Dry” values produce more direct, dry sound in relation to the effect
sound.
Although the “Wet” and “Dry” parameters can be set independently, adjust-
ing one will cause the other to change so that their total is always 100(%).
If a controller is assigned to the “Out1 Dry” or “Out2 Dry” parameter (page
136), an inverse “c” will appear to the right of the parameter.
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8