Filter
Top Products
215UTILITY MODE / SYNTH SETUP
These parameters make it possible to specify what MIDI program change number
is transmitted via the MIDI OUT connector when any of the internal voice or per-
formance memory locations are selected.
4: PROGRAM CHANGE TABLE
[UTILITY] → [SYNTH SETUP] → [MENU] → 4:Program Change Table → [ENTER/YES]
Source
Range: A1 … H8
Controls: [CS5], GROUP, PROGRAM, [-1] [+1], Dial
Specifies the source voice number (GROUP and PROGRAM) which, when
selected on the SY85, will cause the bank and program change numbers speci-
fied by the “MSB”, “LSB”, and “PGM” parameters, described below, to be
transmitted via the MIDI OUT connector.
MSB (Bank select most significant bits)
Range: 000 … 127
Controls: [CS6], [-1] [+1], Dial
Sets the decimal value of the most significant bits of the bank select code
to be transmitted when the source voice number is selected. The specific func-
tions of the bank select codes are determined by individual instrument manufac-
turers, so, if you intend to use these codes, refer to the documentation of the
device you intend to control.
LSB (Bank select least significant bits)
Range: 000 … 127
Controls: [CS7], [-1] [+1], Dial
Sets the decimal value of the least significant bits of the bank select code
to be transmitted when the source voice number is selected. See “MSB”, above,
for more details.
PGM (Program change number)
Range: 00 … 127
Controls: [CS8], [-1] [+1], Dial
Sets the MIDI program change number to be transmitted via the MIDI OUT
connector when the corresponding “Source” voice number is selected.
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8