Filter
Top Products
29PERFORMANCE EDIT MODE / QUICK EDIT
These parameters allow the main LFO and filter parameters of the voices assigned
to each layer to be modified to some degree. The actual LFO and filter parameters of
the voices are not affected, these “offset” values are only effective in the performance
mode.
2: LFO & FILTER OFFSET
[PERFORMANCE] → [QUICK EDIT] → [MENU] → 2:LFO,Filter Offset → [ENTER/YES]
Use PROGRAM keys [1] through [4] (LAYER SELECT A, B, C, and D) to
select the layer to be edited.
Hold the [F1] function key (“ALL”) while editing any of the following
parameters to change its value by the same amount for all layers simultane-
ously.
Speed (LFO speed)
Range: -99 … +99
Controls: [CS3], [-1] [+1], Dial
Modifies the speed of the LFO (this corresponds to the “Speed” parameter
of the main voice LFO — see page 78). Plus (+) values increase the LFO
speed while minus (-) values reduce the speed.
No matter how much offset is applied, the minimum and maximum LFO
speeds cannot be exceeded.
Depth (LFO depth)
Range: -99 … +99
Controls: [CS4], [-1] [+1], Dial
Modifies the amplitude, pitch, and frequency modulation depth of the LFO
(this corresponds to the “Pmod”, “Amod”, and “Fmod” parameters of the main
voice LFO — see page 78 and 79). Plus (+) values produce greater modulation
depth while minus (-) values reduce the modulation depth.
No matter how much offset is applied, the minimum and maximum LFO
depth values cannot be exceeded.
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8