Filter
Top Products
111
Max (Maximum parameter value)
Range: 0 … 100
Controls: [CS5], [-1] [+1], Dial
Sets the upper limit of the [CS1] or [CS2] control range. A setting of
“100”, for example, means that when the slider is set to its highest position the
assigned parameter will also be set to its highest value. A setting of “80”
means that the highest slider position will set the assigned parameter to about
80% of its range (a parameter with a range of 0 to 127, for example, would be
set to about 102).
If a controller is assigned to the “Max” parameter, an inverse “c” will
appear to the right of the parameter.
Additional (Additional MIDI control)
Range: 000 … 120, AfterTch, Velocity, KeyScale, LFO
Controls: [CS6], [-1] [+1], Dial
This parameter allows MIDI control change numbers to be assigned to the
selected effect parameters, so that they can be controlled from the SY85 con-
trollers (modulation wheel, foot controller, etc) or an external MIDI device that
is capable of transmitting control change messages. Additional settings include
“AfterTch” for keyboard aftertouch control, “Velocity” for keyboard velocity
control, “KeyScale” for key scaling control, and “LFO” for internal LFO con-
trol. This is in addition to control via the [CS1] and [CS2] sliders. MIDI con-
trol change numbers 000 through 120 can be assigned. Some control change
numbers are already defined, while others are not assigned to any specific
controller (see chart below).
VOICE EDIT MODE / EFFECT EDIT
MIDI CONTROL CHANGE NUMBER/DEVICE
0: “--------”
1: “Mod.Whl.”
2: “Breath C”
4: “Foot Cnt”
5: “Porta.Tm”
6: “Data Ent”
7: “Main Vol”
8: “Balance ”
10: “Panpot ”
11: “Express.”
64: “Hold 1 ”
65: “Porta.Sw”
66: “Sostenut”
67: “Soft ”
69: “Hold 2 ”
91: “Effect D”
92: “TremoloD”
93: “Chorus D”
94: “CelesteD”
95: “Phaser D”
96: “Inc. ”
97: “Dec. ”
98: “NRPN LSB”
99: “NRPN MSB”
100: “RPN LSB”
101: “RPN MSB”
121: “AfterTch”
122: “Velocity”
123: “KeyScale”
124: “LFO ”