Filter
Top Products
223UTILITY MODE / CARD
1: CARD ALL LOAD/SAVE
[UTILITY] → [CARD] → [MENU] → 1:ALL Load/Save → [ENTER/YES]
Before executing a load or save operation, check the card status as shown
in the upper right corner of the display. If the display shows “Card=<SY85 >”,
a properly formatted MCD64 is installed and the load or save operation can be
executed. If the wrong type of card (wrong format) or no card is installed in
the DATA slot, however, the card status display will show “Card=<------>” and
no load or save operation is possible. You will have to use the card format job,
described next, to format a new memory card or one that has been formatted
for use with a different instrument before the card can be used with the SY85.
Also make sure that the card write protect switch (see MCD64 Memory Card
operation manual) is set to the “OFF” position before attempting to save data to
the card.
Press the [F1] key to highlight “LOAD” on the display if you want to load
the voices and performance combinations from the card into the SY85’s internal
memory, or press the [F2] key to highlight “SAVE” on the display if you want
to save the voice and performance data from the internal memory to the card.
Press [ENTER/YES] to begin the card load or save procedure. The follow-
ing confirmation display will appear:
Press [ENTER/YES] again to confirm that you want to go ahead with the
card load or save operation, or press [EXIT/NO] to cancel.
When the data has been loaded or saved, “Completed!” will appear briefly
on the display.
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
Saves or loads all internal voices and performance combinations to or from a
Yamaha MCD64 memory card plugged into to the DATA card slot.