Filter
Top Products
51PERFORMANCE EDIT MODE / JOB
2: LAYER EXCHANGE
[PERFORMANCE] → [JOB] → [MENU] → 2:Layer Exchange → [ENTER/YES]
This function can be used to eliminate the audible effects of slight note delays
that can occur in the performance play mode. The notes played by layers A, B, C,
and D are sounded in sequence in the performance play mode. Normally the delay is
so slight that it is not audible. If a voice with a sharp attack is assigned to one of the
later layers (C or D), however, the delay can “soften” the attack of the voice. The
problem can be overcome by using this function to exchange layers A and D, for
example, so that the voice with the strong attack is assigned to layer A instead of
layer D. Since layer A is sounded first, the sharpness of the attack will be retained.
Use the [CS7] and [CS8] sliders to select the layers to be exchanged (A
through D), then press [ENTER/YES] to begin the layer exchange procedure.
The following confirmation display will appear:
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
Press [ENTER/YES] again to confirm that you want to go ahead with the
layer exchange operation, or press [EXIT/NO] to cancel.
When the data has been exchanged, “Completed!” will appear briefly on the
display, then the display will return to the mode that was engaged prior to
calling the layer exchange function.