Filter
Top Products
247
This function erases and initializes all wave memory, the specified type of wave
memory, or a single specified sample.
WAVE INITIALIZE
[SHIFT]+[UTILITY] → [SEQ SETUP]
Mem (Memory type)
Range: Volatile, Non-vol., all
Controls: [CS2], [-1] [+1], Dial
Use [CS2] to select either the volatile wave memory (“Volatile Mem.”),
non-volatile wave memory (Non-vol. Mem.”), or all wave memory to be
cleared.
See “Wave Memory Expansion” on page 285 for additional information.
Wave Mem Allocation
Range: 0 … 63, off
Controls: [CS8], [-1] [+1], Dial
All numbers from the number specified here to 63 are allocated for use as
non-volatile waveform and sample numbers.
Press [ENTER/YES] to begin the wave initialize procedure. The following
confirmation display will appear:
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
WAVE EDIT MODE / INITIALIZE
Press [ENTER/YES] again to confirm that you want to go ahead with the
initialize operation, or press [EXIT/NO] to cancel.
When the specified wave memory has been initialized, “Completed!” will
appear briefly on the display.