Filter
Top Products
251WAVE EDIT MODE / DISK
These utilities allow sample data to be saved to or loaded from a 3.5" floppy disk
inserted in the SY85 disk drive.
Use only 2DD type disks that have been formatted for use with the SY85 via the
DISK FORMAT function described on page 235.
WAVE DISK LOAD/SAVE 1 SAMPLE
[SHIFT]+[UTILITY] → [DISK]
Press the [F1] key to highlight “LOAD” on the display if you want to load
data from the disk into the SY85 wave memory, or press the [F2] key to high-
light “SAVE” on the display if you want to save data from the wave memory
to the disk. Next, use [CS5] to select the number of the disk file (01 through
99) that you want to load from or save to. If you select “LOAD”, [CS7] is
used to select the type of wave memory to which to data is to be loaded
(“Volatile” or “Non-vol.”). If you select “SAVE”, [CS7] is used to select the
number of the sample to be saved (00 … 63).
Press [ENTER/YES] to begin the disk load or save procedure. If you select
“SAVE”, you have the option of pressing the [F3] key to give the data file a
name before it is saved (the name is displayed above the file number — un-
named files are automatically named “--NEW--*”). If you choose the “NAME”
option, enter the file name with the group and program keys as in “Voice
Name” (see page 95), then press [ENTER/YES] to begin the disk load or save
procedure. The following confirmation display will appear:
Press [ENTER/YES] again to confirm that you want to go ahead with the
disk load or save operation, or press [EXIT/NO] to cancel.
When the data has been loaded or saved, “Completed!” will appear briefly
on the display.
See page 321 for information on disk error messages
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8