Filter
Top Products
245WAVE EDIT MODE / SAMPLE EDIT
● 2: SAMPLE DATA
If not already selected, press the PAGE [ ] key to select this screen.
These functions allow the volume, pitch, and loop characteristics of each
sample assigned to the waveform to be set individually. If more than one
sample is assigned, start by selecting the sample you want to edit via the
“Sample” parameter, then use the “Vol”, “Pitch”, “Loop”, and “Typ” param-
eters to edit the specified sample.
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
Vol (Volume)
Range: 0 … 127
Controls: [CS3], [-1] [+1], Dial
Sets the volume of the selected sample. A setting of “0” produces minimum
volume (almost no sound), and a setting of “127” produces maximum volume.
Use this parameter to balance the levels of the different samples used in a
waveform.
Pitch
Range: -4158 … +5376
Controls: [CS4], [-1] [+1], Dial
Fine-tunes the pitch of the selected range over a wide range. Minus (-)
settings decrease the pitch of the sample while plus (+) settings raise the pitch
of the sample. Each increment corresponds to a pitch change of approximately
1.7 cents (a “cent” is one-hundredth of a semitone).