Filter
Top Products
170 SONG EDIT MODE / SONG EFFECT
Depending on the selected effects the SY85 effect system can have up to four
separate output levels that are adjusted by the parameters provided in this screen.
4: OUTPUT LEVEL
[SONG] → [EFFECT EDIT] → [MENU] → 4:Output Level → [ENTER/YES]
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
1a, 1b, 2a, and 2b (Effect output levels)
Range: 0 … 100
Controls: [CS3], [CS4], [CS7], [CS8], [-1] [+1], Dial
The [CS3] and [CS4] sliders adjust the output levels of the effect 1 “1a”
and “1b” stages, respectively, while the [CS7] and [CS8] sliders adjust the
output levels of the effect 2 “2a” and “2b” stages. A setting of “0” turns output
from the corresponding effect stage off, while a setting of “100” produces
maximum output level.
If the selected effect is a “single” type, then only the “1a” or “2a” output
level is available. If it is a “cascade” type, then only the “1b” or “2b” output
level is available. Both the “1a” and “1b” or “2a” and “2b” levels are available
only if the selected effect is a “dual” type. The type of the effects currently
selected for the effect 1 and effect 2 processors are shown in parentheses on
the bottom line of the display. See page 254 for details on the effect stages and
the SY85 effect system in general.
If a controller is assigned to any of the output level parameters (page 174),
an inverse “c” will appear to the right of the parameter.