Filter
Top Products
202 PATTERN EDIT MODE / PATTERN JOB
Copies all pattern data from one pattern to any other. This can be handy if you
want to make minor changes to an existing pattern while retaining a copy of the
original pattern data. It is also possible to append one pattern to another, and copy
the result to a new pattern number.
1: COPY PATTERN
[PATTERN] → [JOB] → [MENU] → 1:Copy Pattern → [ENTER/YES]
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
From (Source and append patterns)
Range: 00 … 99
Controls: [CS6], [CS7], [-1] [+1], Dial
To
Range: 00 … 99
Controls: [CS8], [-1] [+1], Dial
Use [CS6] to select the “From” or source pattern number (0 … 99), [CS7]
to select a pattern to be appended to the end of the of the first pattern (leave
this parameter set to “***” if you do not want to append a pattern), and [CS8]
to select the “To” or destination pattern number. The name of the currently
selected “From” or “To” pattern is shown between parentheses on the lower
display line, depending on which parameter the cursor is positioned below.
Press [ENTER/YES] to begin the copy procedure. The following confirma-
tion display will appear:
Press [ENTER/YES] again to confirm that you want to go ahead with the
copy operation (which will overwrite all data in the “To” pattern number), or
press [EXIT/NO] to cancel.
When the pattern data has been copied, “Completed!” will appear briefly on
the display.