Filter
Top Products
112
7: EFFECT LFO
[VOICE] → [EFFECT EDIT] → [MENU] → 7:Control LFO → [ENTER/YES]
All of the modulation-type effects — chorus, flanging, etc. — require LFO con-
trol. The SY85 has an independent effect LFO that is set up by the following param-
eters.
VOICE EDIT MODE / EFFECT EDIT
Wave (LFO waveform)
Range: tri, dwn, up, squ, sin, S/H, 1tm
Controls: [CS4], [-1] [+1], Dial
Determines the waveform of the effect LFO.
“tri” = Triangle “dwn” = Downward sawtooth
“up” = Upward sawtooth “squ” = Square
“sin” = Sine “S/H” = Sample and hold
“1tm” = Upward 1-shot
If a controller is assigned to the “Wave” parameter (page 110), an inverse
“c” will appear to the right of the parameter.
Speed (LFO speed)
Range: 0 … 99
Controls: [CS6], [-1] [+1], Dial
Sets the speed of the effect LFO.
“0” is the slowest Speed setting, producing an LFO speed of approximately
0 Hertz. The fastest setting of 99 produces an LFO speed of approximately 25
Hertz.
If a controller is assigned to the “Speed” parameter (page 110), an inverse
“c” will appear to the right of the parameter.
Delay
Range: 0 … 99
Controls: [CS8], [-1] [+1], Dial
Sets the delay time between the beginning of a note and the beginning of
effect LFO operation for the selected element.
The minimum setting “0” results in no delay, while the maximum setting of
“99” produces a delay of approximately 2.66 seconds before the LFO begins
operation (5.3 seconds before it reaches maximum depth).
If a controller is assigned to the “Delay” parameter (page 110), an inverse
“c” will appear to the right of the parameter.
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
∆ ∆