Filter
Top Products
230 UTILITY MODE / DISK
● 2: MDR SAVE/LOAD
This utility is used to move MDR data between the internal memory and disk. A
SAVE operation saves MDR data from the internal memory to the specified disk file
number, and a LOAD operation loads MDR data to the internal memory from the
specified disk file number.
Press the [F1] key to highlight “LOAD” on the display if you want to load
MDR data from the disk into the SY85 internal memory, or press the [F2] key
to highlight “SAVE” on the display if you want to save MDR data from the
internal memory to the disk. Next, use [CS5] to select the number of the disk
file (00 through 99) that you want to load from or save to.
Press [ENTER/YES] to begin the MDR disk load or save procedure. If you
select “SAVE”, you have the option of pressing the [F2] key to give the data
file a name before it is saved (the name is displayed above the file number —
unnamed files are automatically named “--NEW--*”). If you choose the
“NAME” option, enter the file name in the normal way (see page 95), then
press [ENTER/YES] to begin the disk load or save procedure. The following
confirmation display will appear:
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
Press [ENTER/YES] again to confirm that you want to go ahead with the
disk load or save operation, or press [EXIT/NO] to cancel.
When the data has been loaded or saved, “Completed!” will appear briefly
on the display.
See page 321 for information on disk error messages.