Filter
Top Products
193SONG EDIT MODE / SONG JOB
Allows pitch bend, after touch, program change, or control change events (data) to
be removed from a specified measure or range of measures in a specified track.
This job is not available when the rhythm track (track 9) is selected.
11: REMOVE EVENT
[SONG] → [A]~[H] → [SONG JOB] → [MENU] → 11:Remove Event → [ENTER/YES]
Event (Event type & No. if “ctrl” selected)
Range: PB, AT, crtl, pgm
Controls: [CS5], [CS6], [-1] [+1], Dial
Meas (First & last measure numbers)
Range: 001 … 999
Controls: [CS7], [CS8], [-1] [+1], Dial
Use the GROUP [A] through [H] keys to select the track containing the
measures from which you want to remove events (A = track1, B = track 2, and
so on). The LED of the selected track will glow red while the LEDs of all
other tracks containing data glow green.
Use [CS5] to select the type of event to remove: “ctrl” for control change,
“pgm” for program change, “AT” for aftertouch, and “PB” for pitch bend.
Removing a program change (“pgm”) event also removes control change
number 0 and 32 (bank select). If “ctrl” is selected, [CS6] can be used to
specify a control number to be removed (see below). Use the [CS7] and [CS8]
sliders to select the numbers of the first and last measures in the range of
measures from which the specified event data is to be removed.
Press [ENTER/YES] to begin the remove event procedure. The following
confirmation display will appear:
F1
CS1
F2
CS2
F3
CS3
F4
CS4
F5
CS5
F6
CS6
F7
CS7
F8
CS8
Press [ENTER/YES] again to confirm that you want to go ahead with the
remove event operation, or press [EXIT/NO] to cancel.
When the data has been removed, “Completed!” will appear briefly on the
display.