Filter
Top Products
132
ToTime>=EndTime
■ When using the expand/compress track editing opera-
tion (“ExpCmpTrack”), the TO and END settings you
made were incorrect so that the operation could not be
executed. This message will appear if TO is later than
END, or if they are at the same time location.
→ Set the times correctly.
MemoryFull
■ There is insufficient memory for recording or track edit-
ing.
→ Delete unneeded data.
In some cases, you can solve this problem by turning
the power off and then on again.
MIDIOverflow
■ When receiving MMC or recording MIDI Clock, a MIDI
data reception failure occurred.
→ Delete unneeded data from the transmitting device.
No CDRW Disc
■ The erase destination media is not a CD-RW.
→ Execute the erase command on a CD-RW.
No Event
■ When writing an audio CD, tracks 1/2 did not contain
audio data.
→ Bounce the data to be written to CD into tracks 1/2.
NumberOfTracks
■ During track editing, the number of source tracks is dif-
ferent than the number of destination tracks.
→ Make settings so that the source and destination have
the same number of tracks.
■ Since “Clip” contains no data, data cannot be copied.
→ Either copy data to “Clip,” or select a different copy
source track.
■ When exporting WAV data, there were more than two
tracks in the clip-board.
→ Execute the WAV file export command after copying
two tracks or fewer.
SameFileNameExists!
■ When exporting a WAV file, a WAV file of the same
name already exists in the export destination drive.
→ Specify a different filename.
SongProtected
■ The selected song is protected.
→ Either turn off protect (→p.89), or select a different
song.
TempoFast
■ When recording tempo, the tempo was too fast to be
recorded correctly.
→ If you are recording MIDI clock, set the tempo of the
MIDI transmitting device (sequencer etc.) to a slightly
slower setting.
→ If you are recording tap tempo, please tap at a slightly
slower tempo.
TempoSlow
■ When recording tempo, the tempo was too slow to be
recorded correctly.
→ If you are recording MIDI clock, set the tempo of the
MIDI transmitting device (sequencer etc.) to a setting of
=40 or faster.
→ If you are recording tap tempo, please tap at a slightly
faster tempo.
Track Full
■ When writing an audio CD, the number of tracks (the
number of songs) written to the CD has exceeded 99
songs.
→ Write to new CD media.
Unsupported File Type
■ When importing a WAV file, you attempted to import a
file that was not 8 bit/16 bit/24 bit, 44.1 kHz monau-
ral/stereo.
→ Select a 8 bit/16 bit/24 bit, 44.1 kHz monaural/stereo
file.
Write CD Failed
■ Writing to CD has failed.
→ Select a slower speed for writing to the CD-R/RW.
→ Use the media recommended for your drive.
■ If you are attempting to write to CD from an external
SCSI device, the transmission speed may be insuffi-
cient.
→ You may be able to write successfully if you copy the
data from the external SCSI device to the internal hard
disk, and then write it from the internal hard disk to the
CD.
→ Read the “CD-RW” section of “Troubleshooting.”