Filter
Top Products
Operation–Quick Start
12
The page in which you edit the scene name will appear.
Step 5. Input a scene name using the main encoder, the
pads, or the encoders or sliders.
You can input a name of up to eight characters. For
details, see “Inputting a name” (☞p.22).
Step 6. When you’ve finished inputting the name, press
the OCTAVE SHIFT/CURSOR [®] key or the [ENTER]
key to proceed to the next page.
Step 7. This page asks you for confirmation. To save the
scene, press the [ENTER] key.
When the scene has been saved, the main display will
indicate “Complete” and you will return to Play mode.
If you decide to cancel mid-way through the Save
procedure, press the [EXIT] key.
5.
Managing scene sets on your computer
Using the included Editor Librarian software, the twelve scenes stored in the
KONTROL49 can be saved on your computer as a set for editing and data
management.
Data transfer to and from the
Editor Librarian software is
performed in the Scene mode
DUMP page. (☞p.53)
Step 1. Press the [SCENE] key.
The main display indicates
“ScenePd?”
Step 2. Continue holding
down the [SCENE] key, and
press pad 14 (assigned to the
[DUMP] function).
You will enter the DUMP
page.
Start up the KONTROL49 Editor Librarian software, and press the
“Receive” button to load the scene set from the KONTROL49’s memory.
Then press the “Save” button to name the scene set and save it as a file. A file
you create in this way can be loaded into the KONTROL49 whenever
needed.
For details on using the Editor Librarian software, refer to “Editor Librarian
software manual” on the included CD-ROM.
6
5
7
2
1