Filter
Top Products
Operation–Setting mode
23
■ Using the trigger pads to input text
An alphanumeric character, symbol, or blank is assigned to each pad. Insert
(insert a blank at the cursor location), Delete (delete the character at the
cursor location and tighten up the subsequent characters), and Clear (erase
the character at the cursor location) functions are also provided. The selected
character will alternate each time you strike a pad [5]–[8] or [10]–[16]. Move
the cursor to the position at which you want to input a character, and use the
trigger pads to input or edit characters.
■ Using the encoders and sliders to input text
Regardless of the cursor location, you can use the sliders and encoders to
input the characters shown in the display. Use slider 1 or encoder 1 to input
the first character (counting from the left edge) of the display. Use slider 2 or
encoder 2 to input the second character of the display. In this way, sliders 1–
8 or encoders 1–8 will edit the eight characters shown in the display.
However, you’ll need to use sliders 1–8 to input the name of a parameter
assigned to an encoder. Likewise, you’ll need to use encoders 1–8 to input
the name of a parameter assigned to a slider.
Quick-assign for control changes
In Play mode, there’s a shortcut for assigning a new control change message
to an encoder (or slider if making a slider assignment). This method is valid
only for an encoder or slider which is already assigned to a control change
message.
You cannot use this method for an encoder or slider to which you have
assigned NRPN or RPN.
1
In Play mode, hold down the [SETTING] key and turn the desired
encoder (or slider if making a slider assignment) to select a new control
change message.
The sub-display will show the new assignment for the encoder or
slider.
2
The new control change assignment will be updated when you release
the [SETTING] key or operate a different controller. If you decide to
cancel, press the [EXIT] key before you release the [SETTING] key.
The MIDI channel will still be set to the “MIDI Channel” specified in the
Encoder assignment Slider assignment page.
If you want to keep the changes you’ve made, save them in Scene mode.
If you turn off the power or select a different scene without saving, your
changes will be discarded. For details, see “Scene mode–[16] WRITE”
(☞p.55).
[1]
[5]
[9]
[13]
[14]
[15]
[16]
[2]
[10]
[6]
[3]
[11]
[7]
[4]
[8]
[12]
MIDI channel
Control change number
MIDI message type
Settin
g
mode