Filter
Top Products
Appendices–Troubleshooting
60
■Connected external device or software does not synchronize
• Could the KONTROL49’s MIDI Clock tempo be set to “Clock Off”?
• Check the MIDI Clock settings of the connected device or software.
■Keyboard or pads do not transmit velocity
• If keyboard or pad velocity is assigned to the bend/wheel, the keyboard
or pad velocity is ignored if the value is other than zero.
• Check the velocity settings. (Keyboard: ☞p.38 “[12] KEYBOARD
(Keyboard setting),” Pads 1–8: ☞p.24 “[3] PAD 1–8 (PAD 1–8
assignment),” Pads 19–16: ☞p.26 “[4] PAD 9–16 (PAD 9–16 assignment)”)
■When you assign Polyphonic Pressure to the bend/wheel and play
multiple keys, aftertouch does not apply to some keys
• When using Polyphonic Pressure, if you hold down more than one note
on the keyboard, aftertouch applies only to the note you played last.
■Notes are stuck
• If note messages are assigned to a pad, and the pad is set to Toggle
operation, the corresponding note-off message may not be transmitted in
some cases. If this occurs, execute the Message mode command [3] All
Note Off (☞p.50) or [1] Panic (☞p.49).